SatNOGS Tripods
View
Options
History
1
2
3
4
Introduction
Details
Guide Steps
Review
Quiz
Drill M5 (or what fits) holes on the middle of the vertical sides of the L channel aluminum beams.
Pass the cable ties through the holes and secure them using single cable connector strips.
Once all 3 ties are in place, slide the Φ22 aluminum pipe through the top and the bottom 3D printed brackets.
Secure and tie all bolts. Adjust the height of the aluminum central pipe if needed.
Your tripod is now complete!
You can dissemble and easily carry the tripod by unsecuring 2 of the 3 cable ties, detaching one side for each of the three L channel aluminum beams and loosing the top bracket bolts.
« Previous
Next »
Your contributions are licensed under the open source Creative Commons license.
Next line
Previous line
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.