Pending Edits to SatNOGS Rotator v3 Mechanical Assembly
Step #7 edited: [Step edited]
Edited by Scott Bragg (1)
(You don’t have enough reputation to patrol this edit.)
| [title] Side worm assembly 1 | |
| [* 1] In this step you will need: | |
| [* 8] The previous worm gear assembly. | |
| [* 1] 3D Printed: Worm mount | |
| [* 1] 2 ball bearings 625ZZ | |
| - | [* 1] 4x M4 nut slot 6, 4x M4-10 screws, 2x |
| + | [* 1] 4x M4 nut slot 6, 4x M4-10 screws, 2x M5 washer. |
| [* 3] Insert the ball bearings inside the pockets of the mounts. Then screw the bolts into the nuts slot6 as shown in the pic. | |
| [* 1] Finally slide the worm mounts in the slot 6 rails as shown. First the one without the gear assembly first, then the second with the gear assembly as shown. | |
| [* 5] Don't forget the washers between the ball bearings and the worm gear assembly. |