For the antenna structure assembly you will need everything from previous steps plus the following 3D printed parts:
9x T-connectors, 2x Y-connectors, 1x YO connector
Put 6 of the T-connectors in place as shown, driven by the design.
Make sure not to put the 3 outer ones (as you will need to put the reflector first in place).
Using 6 small PVC pipes (see previous step) glue them in the 6 T-connectors as shown.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.