Next, we need to mark the PVC pipes
Cut 3x140cm Φ16 PVC pipes.
Using the design, mark the T-Holder positions on the pipes (3 each).
Then we need to mark the wire notches on the pipes. Consult the design for exact dimensions. 165mm is the spacing between marks for each pipe.
Make sure that on each pipe the marks are offseted by 1/3 of 165mm from the previous one. Refer to design if in doubt.
Finally, make the notches using a file (tool) on approx. 30 degrees inclination.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.