Position the plexiglass 6 radial base on the corresponding mark on the printout. In the case of a LHCP antenna, follow the picture provided, for a RHCP antenna it should be vice-versa.
Stabilize the plexiglass on the printout using adhesive tape. Position the reflector on the plexiglass and use tie-ups and small wires to tie-up the six small peripheral holes and the 3 inner holes that will not be used to place PVC pipes through them.
Cut the grid on the positions the pipes and the N-type connector will be placed.
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.