Next step is to mark the holes on the box. For this version we are not using an optimal box, and you should prefer a box without existing holes.
Start by marking the bottom 8 holes for the gear assemblies.
Positioning should be driven by the axis lines. Try to center those axis lines within the box. Keep in mind that the 4 holes of each axis are creating a 60x31mm rectangle.
Drill the holes (a hand drill might be easier to use).
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.