Slide the axis tube with the pillar all the way up and hold it firmly in place. Mark a whole in the tube for the Axis gear holding bolt.
Remove the axis tube, and open a through hole in the marked position on the axis tube.
Place the O-rings in Axis Bushing and apply Silicone Based Grease.
Re-slide the axis tube, making sure that you you also slide it through the Homing Sensor Holder and Homing ring before it reaches the Azimuth Gear Assembly.
Screw the M3 50mm bolt of the Axis gear.
Screw all M5 bolts, washers and nuts for the Homing Sensor Holder and Axis Bushing outside the box.
Azimuth Axis is ready!
Your contributions are licensed under the open source Creative Commons license.
Insert a new line below
Insert a new line above
Indent current line
Unindent current line
Delete current line
Navigate to next step.
Navigate to previous step.