Skip to main content

You're viewing a previously published revision of this guide.  View latest revision

Older Newer
  1. Electronics Assembly  You will need:
    • Electronics Assembly You will need:

    • The SatNOGS v2 Mechanical Ground Station Assembly.

    • TP-Link WR703N

    • SatNOGS PCB

    • SatNOGS PSU PCB

    • A 4 port USB hub

    • 2 USB micro cables

    • One double wire for 12V to SatNOGS PCB

  2. Using double sided foam tape, place the TP Link on the side as shown. Place SatNOGS PCB as shown (with foam tape) Place SatNOGS PSU PCB as shown (with foam tape)
    • Using double sided foam tape, place the TP Link on the side as shown.

    • Place SatNOGS PCB as shown (with foam tape)

    • Place SatNOGS PSU PCB as shown (with foam tape)

    • Stick with foam tape and connect the USB hub as shown.

  3. Wires are next: Connect 12V from PSU PCB to PCB using two wires as shown.
    • Wires are next:

    • Connect 12V from PSU PCB to PCB using two wires as shown.

    • Connect Stepper motor wires as shown.

    • Refer to Stepper motor documentation for specifics on colors of wires.

    • Your SatNOGS Ground Station is now all wired up!

Pierros Papadeas

Member since: 4/23/14

965 Reputation

7 Guides authored

View Statistics:

Past 24 Hours: 1

Past 7 Days: 2

Past 30 Days: 21

All Time: 10,998